|
防泄漏产品和技术
|
|
|
|
|
|
|
|
吸附棉MSDS | 文章来源: 点击数:2075 更新时间:2009/5/12 22:22:51 |
| MATERIAL SAFETY DATA SHEET
MSDS Number: 00125 MSDS Date: March 15, 2000 Pages: 1 of 2 Product Name: Meltblown Polypropylene Absorbent Material
Section I: Identification of Product and Company Information
Product Name: Spill Textile Corporation Meltblown Polypropylene Absorbent Material Chemical Family: Olefin Chemical Name: Polypropylene Product Type: Hydrophobic/Hydrophilic/Static Resistant
Company Identification: Spill Textile Corporation 205 Lakeshore Drive Port Arthur, TX 77640 409-983-7800 409-985-2566 (fax)
Section II: Composition/Information on Ingredients
Material: Polypropylene < or = 100% Proprietary additives < or = 0.01% (trade secret)
Occupational Exposure Limits: None established by OSHA or ACGIH
Section III: Physical Data
Appearance/Color: White – Hydrophobic/Oil Only Blue – Hydrophobic/Oil Only Gray – Hydrophilic/Universal Green – Hydrophilic/Universal Pink – Static Resistant/Labeled White – Static Resistant/Labeled
Odor: Virtually odor free Specific Gravity: 0.88 – 0.92 Boiling Point: Not Applicable Melting Point: >160 degrees Celsius Solubility in Water: Insoluble Percent volatile by volume: Not Applicable Evaporation Rate: Not Applicable Vapor Pressure: Not Applicable Vapor Density: Not Applicable
MSDS Number: 00125 MSDS Date: March 15, 2000 Pages: 2 of 2 Product Name: Meltblown Polypropylene Absorbent Material
Section IV: Fire and Explosion Hazard Data
Flash Point: >329 degrees Celsius (Pensky-Martens Closed Cup ASTM D93) Flammable Limits: Not Applicable Extinguishing Media: Water, Foam, CO2, Dry Chemical Special Fire Fighting Procedures: Standard procedure for Class A fires. Unusual Fire and Explosion Hazards: Some carbon monoxide formation is possible under oxygen lean conditions.
Section V: Health Hazard Data
No special procedures required.
Section VI: Stability and Reactivity Data
This material is stable and hazardous polymerization will not occur. Avoid contact with hot or concentrated nitric and perchloric acid, sulfuric acid or 98% sulfuric acid at 60 degrees Celsius or above.
Section VII: Spill or Leak Procedures
Collect and deposit in a suitable container away from heat and ignition. Dispose of in a sanitary landfill or incinerate in compliance with state, federal, and local regulations.
Section VIII: Preparation
The information contained herein is given in good faith, but not warranty expressed or implied is made. Date Issued: March 15, 2000. Prepared by: STC Safety Committee.
| | |
| 上一篇:了解二次包装桶和泄漏应急桶的区别 下一篇:当泄漏发生时..........
|
|
|
|
|
|
|